Pontiac/Ford/Chevy/Datsun parts

Pictures available upon request. All prices are pre-shipping cost.

PONTIAC
Parts here for Pontiac V8 engines sized 301-455 '66-up.
remanfactured aluminum pump $5
Recently remanufactured starter $5
V8 distributor $5

FORD
1963 gauge clusters both for $30, or one for $20.

SBC & general GM parts..
C4 Corvette calipers (2) Used. Both are L side (driver) calipers $20ea/30 both
S10/S15 speedometer cable (mechanical speedo) New in box $25
1st gen S truck 'sport' style mirrors. Both pass & driver side manual operation mirrors. $20 New - out of box
'65 corvette rams horn exhaust manifolds. 2" collectors. Painted black $30
Set of Chevy 4.8/5.3 heads. $40.
Heater controls for '98- up S trucks w/out A/C, heated mirrors or rear defrost. The back plug in is cracked, the knobs are a little dirty & in rough shape. $5.
OEM radio head units. I have two to choose from. One's an AM/FM & a tape player & the other is just plain old AM/FM. If you'd like a pigtail of wire off the stock connector I only have one left. $5 (each).
Triple gauge kit w/ chrome mounting bracket. Mechanical gauges. Coolant temp, Oil pressure & an Ampmeter. $10. New in box
Screw-in Rocker studs. 3/8" top 7/16" bottom. These are used. They were made by GM. $10.
Reverse rotation flex-a-lite flex fan. $5
S10 V8 conversion headers are Sanderson coated for the S10 V8 conversion, 1-3/4" primary tubes, 3" collectors & solid 3/8" flanges (used) .. $240
S10 V8 conversion motor mount plates. New. Use 4.3 mounts $40 (only $10 if you buy the headers, too!!)
Propane 'carb'/throttle body - $30

DATSUN/NISSAN
Datsun 240Z Grille. Great condition. $10
Datsun alternator. $5

I have a set of leather Corbeau seats I got a few years ago for  $1200. Seat brackets were another $200 at the time. I used them in my T-bird for about 3 months, sold the car & have stored them in the house since.  No rips, no tares. They are black. $500/obo. for the seats w/ the seat tracks. Seat tracks fit '89-97 T-birds/Cougars. You can get new seat tracks, or use your old ones, to mount these in a different vehicle.

Jason will the mandrel bent tailpipe fit my 4dr?

http://www.summitracing.com/parts/WLK-45673/ That's the tailpipe. According to the application list it does.. but then it also says it exits on the drivers' side. Maybe In europe it does but here it exits on the pass side.

Added a few parts.

http://www.summitracing.com/parts/WLK-45673/ That's the tailpipe. According to the application list it does.. but then it also says it exits on the drivers' side. Maybe In europe it does but here it exits on the pass side.

I went and looked at that link,and with some imagination,that shows to exit on the pass side.

I can grab it next time I go out to the other house. I need to get some gutter gaurds up before it gets cold & the leaves start falling.

Added a few more parts.. & removed a couple.

Updated. Scrapped a bunch of stuff & some I-beams.. 1370# worth of stuff scrapped not including all the aluminum. I'm moving soon & would like this stuff mostly gone.